Electronics Forum | Tue Nov 19 02:59:24 EST 2002 | yngwie
Hi Experts out there, pls help me with the following matters. How important is the bare PCB baking ? What is the temperature for baking @ what RH ? What would be the impact for the ENTEK finished board should the baking is really necessary ? For t
Electronics Forum | Wed Nov 20 16:53:18 EST 2002 | davef
Q1: How important is the bare PCB baking ? A1: Baking boards is a non-value added activity. Q2: What is the temperature for baking @ what RH ? A2: Search the fine SMTnet Arcives for bake recipes. Q3: What would be the impact for the ENTEK finishe
Electronics Forum | Thu Nov 21 14:17:27 EST 2002 | MA/NY DDave
Hi I can't give you the answer for your question because I have too many questions and would have to know a lot more before I was comfortable giving any advice. I have done mass Baking of piles of PCB's as a needed evil when piles of boards were ex
Electronics Forum | Fri Nov 22 08:57:56 EST 2002 | davef
Q1: What do you mean by "if the board is manufactured properly"? A2: If the epoxy is noy cured prooperly, for instance, the copper will not be well attached to the glass. So, peel strength will be lower. Q2: I don't believe that the peel off/or lif
Electronics Forum | Wed Nov 20 21:04:15 EST 2002 | yngwie
Hi Dave, What do you mean by "if the board is manufactured properly". If the board is not manufactured properly, humidity will have an impact on the peel strength? Is that what you mean. How does the Humidity impacted the peel strength ? Thru' which
Electronics Forum | Fri Nov 22 10:38:30 EST 2002 | slthomas
The follwing is from the Technet archives, per IPC's Jack Crawford. I dug it up during some investigation of a supplier's issues with humidity in an Asian plant: There is support for this in IPD-HDBK-001 w/Amendment 1 Handbook and Guide to Suppleme
Electronics Forum | Tue Oct 30 21:42:32 EST 2001 | surachai
I have question about board baking after in line washing machine then I would like to know some information that ; 1) Do we need board baking after in line washing machine? Both bare board and assembly borad normally we don't bake . 2)In case of ne
Electronics Forum | Tue Aug 26 03:48:44 EDT 2008 | eyalg
Does anyone know if the IPC 610 standard call for baking bare boards (PWB) prior assembly? Note: I am talking about bare boars only and NOT plastic packages components, Regards. Eyal Green
Electronics Forum | Mon Mar 12 08:00:14 EDT 2007 | rgduval
It sounds like you may be thinking of two different test methodologies. What is required? Bare-bard testing, to verify pcb fabrication? Or populated board testing, to verify manufacturing? If it's bare board testing, the fab house should advise a
Electronics Forum | Fri Jun 18 23:13:08 EDT 1999 | Earl Moon
| | | Carson Valley Inn be hanged, | | | | | | Moonman | | | | | Carson Valley Inn, Wow they should have a plague there that says, "Mike Cox once Stayed here", Good Ol days | | | | Mike, until 4 years ago when I built my current home and moved,
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
